Store the patch you would like to be the new init patch as 'init_patch.s6' on your computer. You may insert any additional information between the name 'init_patch' and the file extension 's6'. For example, you could name it 'init_patch_binaural_pad.s6'.
After naming and saving your custom init patch, copy it to the Super 6's boot drive:
-
Enter bootloader mode:
- Turn off the Super 6 and wait a few seconds.
- Whilst holding down the SHIFT button, turn on the Super 6 and continue to hold the SHIFT button.
- The LEDs of buttons 1-8 and A-H light up one by one to indicate the loading progress while the LED of the SHIFT button is flashing. (Make sure this is the case. If not, repeat step 2.)
- Release the SHIFT button.
- Connect the Super 6 to your computer using a USB cable.
- The Super 6's boot drive appears as a disk drive named SUPER6-BOOT on your computer.
- Delete the init patch file 'init_patch.s6' from the SUPER6-BOOT drive and make sure to empty the trash if you are a macOS user.
- Copy the desired init patch file from your computer to the SUPER6-BOOT drive. If asked if you want to copy files without properties, choose 'yes'. Do not turn off the instrument or unplug the USB cable during the transfer!
- When the transfer is complete, disconnect the USB cable.
- Turn off the Super 6, wait a few seconds and turn it on again.
Note: If no init patch file is stored on the Super 6's boot drive, the Super 6 will load the last active patch upon power cycle. If no patch file is stored on the Super 6's patch drive, the Super 6 will start in manual mode.